If the Insert is set to POST, this tap will pull before the insert is applied to the channel. You may also notice that if you have Dynamics set to PRE that the PostEQ signal tap and the PreFdr signal tap are the same things.

One thing to note, if you have Dynamics set to POST, this tap will pull audio off of the channel after the Dynamics. The latter will automatically return the audio to X32 channels outside the normal first sixteen used for recording from. You can select any pair but I would suggest either 1/2 or 17/18. Any channel fader movements will NOT affect the signal coming out of the output taps up to this point. So in your Audition Multitrack session go down to the Master track and from the drop down menu of the Output box select a Stereo pair of the X32s USB channels.

PreFdr Р Р†Р вЂљРІР‚Сљ This tap is before the channel fader.

When the Dynamics is set to Р Р†Р вЂљР’ВPOSTР Р†Р вЂљРІвЂћСћ then the Р Р†Р вЂљР’ВPost EQ signal tapР Р†Р вЂљРІвЂћСћ is before the Dynamics section. The Dynamics is configurable to be pre or post EQ when it is set to Р Р†Р вЂљР’ВPREР Р†Р вЂљРІвЂћСћ, the Р Р†Р вЂљР’ВPost EQ signal tapР Р†Р вЂљРІвЂћСћ will include the dynamics as seen in the graphic below. (This would be beneficial if an inserted effect was desired, but not the EQ). It will be set to 1-4 for one half and 5-8 for the second set, and then of course 9-12 and 13-16 for the last two sets. In the XLR out menu, the output ports can be changed in groups of 4.

The X32's routing menu has a tab on the very end called XLR out. There is also a configurable option to have the Insert before this tap, so you can have the Insert set to Р Р†Р вЂљР’ВPREР Р†Р вЂљРІвЂћСћ and have this tap pull the audio off of the channel after the insert. See below for release notes from Behringer.

PreEQ Р Р†Р вЂљРІР‚Сљ This tap is before the EQ but after the Gate.

Being before any of the EQ and dynamics, this would be the cleanest unprocessed audio from each channel available.

IN/LC Р Р†Р вЂљРІР‚Сљ This tap is directly after the Input, Preamp Gain and Low Cut.

In X32-Edit v3+ you will see them listed like this:

Behringer x32 usb output routing